KitchenAid · Dishwashers
KitchenAid dishwasher F1E1: The control module may have a fault
THE SHORT ANSWER
The control module may have a fault.
KitchenAid identifies F1E1 with this condition: The control module may have a fault.
Confirm the complete F1E1 display before applying its 30-second reset.
Do not open electrical covers. This reset does not apply to separate leak-protection codes such as F8E5.
WHAT YOU MAY NOTICE
Symptoms to record
- F1E1 appears on the appliance display.
UNDERSTAND THE POSSIBILITIES
Causes & useful observations
A code identifies a condition. It does not, by itself, confirm which part needs repair.
| Possible cause | What to look for | Safe check / next step |
|---|---|---|
| Control moduleService may be needed | This is the manufacturer’s possible fault area, not a confirmed failed part. | Have a qualified technician assess the circuit if the reset does not clear it. |
WORK THROUGH THE BASICS
Safe troubleshooting checks
Use the checkboxes to keep track as you read. Stop at any warning or step that does not match your appliance.
Disconnect power for 30 seconds at the accessible plug or dishwasher breaker, then restore it.
What to noteThe control restarts.
If the code appears again, contact KitchenAid with the model and exact code.
What to noteA recurring fault needs diagnosis.
YOUR NEXT DECISION
When to stop and get help
Arrange service if F1E1 persists or returns after the documented owner check.
THE EVIDENCE
Sources & verification
Our explanations are editorial summaries of the documentation below. They do not replace the instructions for your exact appliance.
- F1E1 - Dishwasher
KitchenAid · Manufacturer support · Checked
Code-specific explanation and owner troubleshooting — KitchenAid dishwasher families covered by the cited manufacturer support pages; confirm the complete model before applying guidance.