LG · Washing machines
LG Top-Load Washer FE: The detected water level is too high
THE SHORT ANSWER
The detected water level is too high
FE indicates the detected water level is too high. Check whether water continues entering after the washer is stopped.
Check whether water continues entering after the washer is stopped.
Avoid wet plugs and outlets. Never open a water-filled front door or continue a cycle that is overflowing.
WHAT YOU MAY NOTICE
Symptoms to record
- The display shows FE.
WORK THROUGH THE BASICS
Safe troubleshooting checks
Use the checkboxes to keep track as you read. Stop at any warning or step that does not match your appliance.
Close the water supply. If safe and supported by the model, use drain-only or spin-only to remove excess water, then leave the washer unplugged for service.
What to noteUse the result to decide whether the issue is resolved or needs service.
THE DETAILS MATTER
Scope & troubleshooting notes
Interpret this code in context
Continued filling with the controls off is useful information for the technician. A reset should not become a reason to leave an overfilling washer unattended.
YOUR NEXT DECISION
When to stop and get help
Arrange service for continued filling or a returning FE indication.
THE EVIDENCE
Sources & verification
Our explanations are editorial summaries of the documentation below. They do not replace the instructions for your exact appliance.
- LG Top Load Washer — LED Blinking Error Codes
LG USA · Manufacturer support · Checked
Error-code troubleshooting; relevant display identified in the article — LG washers using the documented LED diagnostic indications.