Whirlpool · Washing machines
Whirlpool Washer Err: Rejected Cycle Command
THE SHORT ANSWER
The washer may be rejecting a change during operation or a start request with the door open.
Err: The washer may be rejecting a change during operation or a start request with the door open.
Note which control action immediately preceded Err.
Keep hands out of a moving drum. Never force the door or bypass a lock.
WHAT YOU MAY NOTICE
Symptoms to record
- The display reports Err.
UNDERSTAND THE POSSIBILITIES
Causes & useful observations
A code identifies a condition. It does not, by itself, confirm which part needs repair.
| Possible cause | What to look for | Safe check / next step |
|---|---|---|
| Rejected Cycle Command | The triggering action helps distinguish this message from a specific component fault. | Note which control action immediately preceded Err. |
WORK THROUGH THE BASICS
Safe troubleshooting checks
Use the checkboxes to keep track as you read. Stop at any warning or step that does not match your appliance.
Close the door before starting; follow the manual when pausing or changing a running cycle.
What to noteThe requested action is valid for the cycle state.
Use the documented five-minute power disconnect when safe; seek help if normal commands still fail.
What to noteThe controls accept a valid request.
THE DETAILS MATTER
Scope & troubleshooting notes
Before choosing instructions
Match the appliance family and complete display to the source; an identical code on another appliance can mean something different.
YOUR NEXT DECISION
When to stop and get help
Request service if Err remains or returns after the supported checks.
THE EVIDENCE
Sources & verification
Our explanations are editorial summaries of the documentation below. They do not replace the instructions for your exact appliance.
- Err - Error Code - Front Load Washer
Whirlpool · Manufacturer support · Checked
Code meaning and Possible Solutions — Whirlpool front-load washers covered by the cited support article.