Whirlpool · Washing machines
Whirlpool Washer HC: Hot and Cold Hoses Reversed
THE SHORT ANSWER
The hot and cold inlet connections are reversed.
HC: The hot and cold inlet connections are reversed.
Trace each supply hose to its labeled washer inlet.
Keep hands out of a moving drum. Never force the door or bypass a lock.
WHAT YOU MAY NOTICE
Symptoms to record
- The display reports HC.
UNDERSTAND THE POSSIBILITIES
Causes & useful observations
A code identifies a condition. It does not, by itself, confirm which part needs repair.
| Possible cause | What to look for | Safe check / next step |
|---|---|---|
| Hot and Cold Hoses Reversed | This code is reported at cycle end; temperature selection alone does not fix reversed hoses. | Trace each supply hose to its labeled washer inlet. |
WORK THROUGH THE BASICS
Safe troubleshooting checks
Use the checkboxes to keep track as you read. Stop at any warning or step that does not match your appliance.
Shut off both water supplies before hoses are reversed according to the installation instructions.
What to noteEach inlet receives the intended supply.
Check for leaks and run a cycle after the installation is corrected.
What to noteHC no longer appears at the end.
THE DETAILS MATTER
Scope & troubleshooting notes
Before choosing instructions
Match the appliance family and complete display to the source; an identical code on another appliance can mean something different.
YOUR NEXT DECISION
When to stop and get help
Request service if HC remains or returns after the supported checks.
THE EVIDENCE
Sources & verification
Our explanations are editorial summaries of the documentation below. They do not replace the instructions for your exact appliance.
- HC - Error Code
Whirlpool · Manufacturer support · Checked
Code meaning and Possible Solutions — Whirlpool top-load washers covered by the cited code page.