Electrolux · Washing machines
Electrolux washer SU dS: The washer has detected excessive foam
THE SHORT ANSWER
The washer has detected excessive foam.
Electrolux identifies SU dS with this condition: The washer has detected excessive foam.
Check that the detergent is high-efficiency type and that the dose is appropriate.
Do not add improvised chemicals. Stop if foam or water reaches electrical areas.
WHAT YOU MAY NOTICE
Symptoms to record
- SU dS appears on the appliance display.
WORK THROUGH THE BASICS
Safe troubleshooting checks
Use the checkboxes to keep track as you read. Stop at any warning or step that does not match your appliance.
The washer adds rinses until the suds clear; Cancel can dismiss the alert message.
What to noteThe protective rinsing reduces foam.
If needed and safe to run, use an empty Quick Wash. Reduce excess detergent on later loads.
What to noteNormal cycles no longer require repeated suds-removal rinses.
THE DETAILS MATTER
Scope & troubleshooting notes
Longer cycle time
Additional rinsing extends the cycle; this is part of the oversudsing response.
YOUR NEXT DECISION
When to stop and get help
Arrange service if SU dS persists or returns after the documented owner check.
THE EVIDENCE
Sources & verification
Our explanations are editorial summaries of the documentation below. They do not replace the instructions for your exact appliance.
- Laundry front loading washer displaying Error Code SU dS too many suds.
Electrolux · Manufacturer support · Checked
Code-specific explanation and owner troubleshooting — Electrolux front-loading washers covered by the SU dS US support page.