Miele · Washing machines
Miele washer F373 code: leak at a loose drain filter
THE SHORT ANSWER
Leak at a loose drain filter
Miele washer F373 identifies leakage around the drain filter when the filter has not been tightened.
Check whether the drain filter was recently cleaned and refitted.
Keep the cabinet closed. Never bypass the lock. Avoid electrical connections if water or damage makes access unsafe.
WORK THROUGH THE BASICS
Safe troubleshooting checks
Use the checkboxes to keep track as you read. Stop at any warning or step that does not match your appliance.
When access is dry and safe, tighten the drain filter as the model instructions describe. Do not remove it from a water-filled, hot machine.
What to noteThe filter is properly seated and tight.
If the filter cannot seal correctly or leakage continues, stop and ask Miele for service.
What to noteNo new water escapes around the filter.
THE DETAILS MATTER
Scope & troubleshooting notes
Code context
This warning points to the filter area. Inspecting its seating is more relevant than immediately treating it as a general electronic failure.
YOUR NEXT DECISION
When to stop and get help
Contact Miele if the fault persists. Stop for leakage, burning smells or repeated breaker trips.
THE EVIDENCE
Sources & verification
Our explanations are editorial summaries of the documentation below. They do not replace the instructions for your exact appliance.
- Washer fault F373
Miele USA · Manufacturer support · Checked
Fault meaning and recommended response — Miele washing machines and washer-dryers covered by the cited Miele USA fault guidance. Confirm the exact model before following model-dependent instructions.